Victron Energy Phoenix Inverter 12/2000 Smart

Intelligent inverter Victron Energy Phoenix 12/2000

Phoenix Inverter Smart is an efficient and reliable inverter.

Features:

• The inverters are short-circuit resistant and protected against overheating caused by overload or high ambient temperatures.
• Low battery voltage.
• Shutdown and restart levels for low battery voltage.
• Dynamic tripping: load-dependent tripping level.
• Output voltage: 210 - 245 В.
• Frequency: 50 Hz or 60 Hz.
• Enable/disable ECO mode and level sensor for ECO mode.

Communication port VE.Direct:

• The VE.Direct port can be connected to a computer (VE.Direct to USB interface cable required) to configure and monitor the same parameters.

High starting power:

• It is necessary to switch on consumers such as power converters for LED, halogen lamps or power tools.

ECO mode:

• In ECO mode, the inverter goes into standby mode when the load drops below a certain setpoint. In the standby mode, the inverter turns on for a short period of time, every 2.5 seconds (configurable). If the load exceeds the set level, the inverter remains on.

Remote start/stop:

• A remote switch or relay contact can be connected to the two-pin connector. In addition, the left (H) pin of the two-pin connector can be connected to the positive battery terminal or the right (L) pin of the two-pin connector can be connected to the negative battery terminal (or, for example, the vehicle chassis).

LED diagnostics:

• Please refer to the manual for a description.

Switching the load to another AC power source: switch.

For our low power inverters, we recommend using a Filax switch. The Filax has a very short switching time (less than 20 milliseconds), so computers and other electronic equipment will continue to operate without interruption. Alternatively, use a MultiPlus device with a built-in switch.